What We Can Cut: Materials & Thickness Capabilities
At Bay Area Waterjet, our state-of-the-art Techni Waterjet system offers unparalleled precision and versatility. Whether you need an intricate design cut from delicate glass or a heavy-duty mechanical part carved from solid steel, our abrasive waterjet technology can handle it without creating heat-affected zones (HAZ) or mechanical stress.
Below is a comprehensive guide to the materials and thicknesses we can process.
Materials We Cut
Our Techni Waterjet can cut almost any material on earth. Because it is a cold-cutting process, it preserves the structural integrity of your material without warping, melting, or hardening the edges.
Metals & Alloys
We easily slice through both ferrous and non-ferrous metals, providing smooth edge finishes that often require no secondary machining.
Aluminum
Stainless Steel, Carbon Steel, and Tool Steel
Titanium
Brass and Copper
Inconel, Hastelloy, and other exotic aerospace alloys
Stone, Tile & Glass
Waterjet cutting is the industry standard for intricate architectural and decorative designs.
Granite, Marble, and Quartz
Porcelain and Ceramic Tile
Glass (Note: We cannot cut tempered glass, as it is designed to shatter upon piercing)
Concrete
Plastics, Composites & Wood
Our equipment cuts composites cleanly without fraying or delamination.
Carbon Fiber and Fiberglass
Acrylic and Polycarbonate
HDPE, PVC, and Nylon
Hardwoods and Plywood
Soft Materials (Water-Only Cutting)
For softer materials, we turn off the abrasive garnet and use a pure, hyper-pressurized stream of water.
Rubber and Silicone
Foam and Sponge
Cork, Felt, and Textiles
Thickness Capabilities
The sheer power of our Techni Waterjet allows us to cut through incredibly thick materials while maintaining tight tolerances. While cutting speeds vary based on the density of the material and the desired edge finish, our general thickness capabilities are as follows:
| Material Category | Typical Maximum Thickness | Notes |
| Metals (Steel, Aluminum, etc.) | Up to 6″ – 8″ | Optimal precision is achieved under 4″, but we can power through heavy plate stock up to 8 inches. |
| Stone & Ceramics | Up to 6″ | Cuts smoothly without chipping the fragile surface glaze. |
| Plastics & Composites | Up to 8″ | Clean cuts with no melting, burnt edges, or toxic fumes. |
| Foam & Rubber | Up to 10″ | Easily handles thick, bulky blocks with sheer precision. |
| Thin/Foil Materials | Down to 0.010″ | We can stack-cut thin materials for high-volume efficiency. |
Note: The exact thickness we can cut depends on the specific material grade and the edge quality you require for your project. If you have a material thicker than what is listed above, please reach out to us!
Why Choose Our Techni Waterjet?
No Heat-Affected Zone (HAZ): Your material’s temper and properties remain perfectly intact.
Minimal Kerf: The ultra-thin cutting stream allows for intricate details and complex geometries.
Eco-Friendly: Our process uses natural garnet abrasive and water, producing no hazardous gases or toxic waste.
Ready to start your project?
[Contact Us for a Free Quote] | [Upload Your CAD File]